89
V530-R160
Operation Manual
SECTION
4
Under
s
ta
nding
Se
tt
ing
Oper
ation
s
SECTION 4
Basic Operations
Various commands can be input from a host device in addition to the trigger input.
Via the parallel I/O
Refer to page 194 (Sec.8).
Via the serial interface port using Normal communications
Refer to page 212 (Sec.8).
Via the serial interface port using Host Link communications
Refer to page 240 (Sec.8).
Reading judgements can be output to host devices via the serial interface.
Via the serial interface port using Normal communications
Refer to page 227 (Sec.8).
Via the serial interface port using Host Link communications
Refer to page 243 (Sec.8).
Read images can be stored.
Up to 35 images can be stored in memory. Once 35 images have been stored, the existing images
will be overwritten in order starting with the oldest.
Move to
SYS/Image storing
and change the conditions for image storage.
To store NG images only, select
Only NG
, and to store images regardless of the reading result,
select
All
.
Read images can also be backed up automatically to the Memory Card.
Turn ON
SYS/ Image storing /Store to MemCard
.
Refer to page 182 (Sec.7).
Reading can be repeated for stored images.
Display the desired stored image using the
SHIFT
+
Up/Down
Keys and press the
SHIFT
+
TRIG
Keys to execute reading.
Reading can also be repeated for freeze images without re-inputting the image using the
SHIFT
+
TRIG
Keys. By reading an image again after adjusting the reading conditions, you can check if the
conditions are appropriate.
The light will gradually become dimmer as it is used, so adjust the reading conditions periodically.
The light dims about 20% in 1500 hours of use. (Applies to Intelligent Lighting)
