152
SE
CTION
6
Backing Up D
ata
V530-R160
Operation Manual
SECTION 6
Other Functions
1.
Connect the COM1 port on the computer and the V530-R160 using an RS-232C cable.
2.
Make the V530-R160 communications settings (serial).
The default communication settings are as shown in the following table. These settings can be normally
used.
* Both XMODEM and ZMODEM transfer protocols are supported. Use the protocol that matches the com-
puter settings.
3.
Start the Hyper Terminal program on the computer and make the following communication set-
tings.
The same communication settings must be used on both the V530-R160 and the modem on the computer.
* XMODEM or ZMODEM protocol is used, so flow control is not performed.
Item
Setting
Communications protocol
RS-232C
Baud rate
38400 (bps)
Data length
8 (bit)
Parity bits
None
Stop bits
1 (bit)
Protocol
XMODEM*
Item
Setting
Baud rate
38400 (bps)
Data bits
8 (bit)
Parity bits
None
Stop bits
1 (bit)
Flow control
None*
