General
Status
(hex)
Additional
Status
(hex)
Explanation
01
0317
Either the segment is not present or the encoded value in the network segment is
invalid.
01
0318
Link address to self is invalid.
01
0319
Resources on secondary are unavailable.
01
031A
Connection is already established.
01
031B
Direct connection is already established.
01
031C
Others
01
031D
Redundant connection mismatch.
01
031E
There are no more reception resources available on the sending module.
01
031F
No connection resources exist for the target path.
01
0320 - 07FF
Vendor specific.
01
0801
Incompatible Multicast RPI. An existing connection has been established at a dif-
ferent RPI.
01
0802
Invalid Safety Connection Size
01
0803
Invalid Safety Connection Format
01
0804
Invalid Time Correction Connection Parameters
01
0805
Invalid Ping Interval EPI Multiplier
01
0806
Time Coordination Msg Min Multiplier
01
0807
Network Time Expectation Multiplier
01
0808
Timeout Multiplier
01
0809
Invalid Max Consumer Number
01
080A
Invalid CPCRC
01
080B
Time Correction Connection Id Invalid
01
080C
SCID Mismatch. The SCID was non-zero and did not match the value in the tar-
get
01
080D
TUNID not set. Device is out-of-box and TUNID has not been set, so connections
are not allowed.
01
080E
TUNID Mismatch. The TUNID provided does not match. The message was likely
routed to this node in error
01
080F
Configuration operation not allowed
01
0810
No target application data available
01
0811
No originator application data available
01
0812
Node address has changed since the network was scheduled
01
0813
Not configured for off-subnet multicast
01
0814
Invalid Produce/Consume Data Format
Appendices
A - 85
NX-series Safety Control Unit User's Manual (Z930)
A-7
CIP Response Codes
A
A-7-2 Extended Status Codes
Summary of Contents for NX-SIH400
