Sysmac Studio
Setting, programming,
and debugging the Safety Control Units
Safety Control Unit
EtherNet/IP
EtherNet/IP Coupler Unit
Slave Terminal
Additional Information
• Standalone safety control system does not support CIP Safety on EtherNet/IP communica-
tions.
• The EtherNet/IP Coupler Units support connection of NX-SL3300 Units, NX-SI
££££
Units
and NX-SO
££££
Units. It does not support connection to NX-SL5
£££
Units and NX-
SL3500 Units.
1-1-2
Features of Safety Control Unit
Achieving Safety Control System on CPU Rack or EtherCAT Net-
work
l
Integrating Safety Controls in a Sequence and Motion Control System
You can use NX-series Safety Control Units to integrate a safety control system into a sequence
and motion control system.
The safety I/O communications support the FSoE protocol and can be built in as a subsystem on
the NX Bus of CPU Unit or EtherCAT network. Therefore, no special safety control communications
cables or interface devices are required for safety communications.
l
Easy Creation of an Interface with the Standard Controls
You can exchange data between the safety controls that are based on the Safety CPU Unit and the
standard controls that are based on the NJ/NX-series CPU Unit.
This allows you to maintain the independent nature of the previously separate safety controls and
standard controls while easily interfacing monitoring and commands between them.
Achieving Safety Control System on EtherNet/IP Network
l
CIP Safety on EtherNet/IP Is Supported
You can combine an NX-series NX-SL5
£££
Unit with an NX-series CPU Unit to enable CIP Safe-
ty-based communications between devices that support CIP Safety on EtherNet/IP or other Safety
CPU Units.
1 Overview
1 - 5
NX-series Safety Control Unit User's Manual (Z930)
1-1
Introduction and Features
1
1-1-2
Features of
Safety Control Unit
Summary of Contents for NX-SIH400
