![background image](http://html1.mh-extra.com/html/omron/f10-c20/f10-c20_instruction-sheet_741247014.webp)
22
21
Plain Measurement with A.T.OFF
The deviation and average density in
the area enclosed by dotted lines are
registered.
projected.
The
dotted
lines are not
The deviation and average
density in the Teaching area
are registered.
If the set level of measurement item selection is higher than the deviation
level, plain
measurement will be performed.
*) By another mode, it is possible to enlarge Detection Range.
Teaching Area
The deviation and average density in
the Teaching area are registered in
the above example.
The
sensing
area
is
restricted so that the
pattern
close to the
edge will not influence
the
results
of
object
discrimination.
The pattern is outside the Sensing area.
Teaching
is
performed in the Teaching
area.
the
The pattern close to the edge of
sensing area
is
not
registered
as
a
model
because such a
pattern
may
not
be
always
located
in
the
sensing
area
and accurate measurement
cannot
be
performed. In
this
example,
the
deviation level
in the area
enclosed
by
the
dotted
line
is
small. Therefore, plain
measurement
will
be performed.
Plain Measurement
8
7
6
5
4
3
2
1
Deviation
High
Low
Measurement item
selection level
Plain Measurement with A.T.ON
8
7
6
5
4
3
2
1
Deviation
High
Low
Measurement item
selection level
*) By another mode, it is possible to enlarge
Detection Range
.
Upper Detection Range
Detection Range
Detection Range
Detection Range
8
7
6
5
4
3
2
1
Deviation
High
Low
A
Detection Range
Measurement item
selection level
Measurement Item: PATT/PLN
Whether measurement is patterned or plain is determined automatically by
comparing the contrast with the background within the detection range. When
teaching is finished, all the level indicators will light for 0.5 s, and the buzzer will
sound twice.
Pattern Measurement
The portion with the highest
deviation is registered as a
model.
The deviation level will become high if the senseing object has a pattern. If the
deviation level is htgher than the set level of measurement item selecton,
pattern measurement will be performed.
The set level of measurement item selection is increased or
decreased by pressing the SELECT buttons. Adjust the level
according to the background and deviation. The level is factory-
set between 2 and 3.
If the object has some light-color lines or light-color patterns,
pattern measurement may be performed. In this case, by
increasing the set level of measurement item selection, plain
measurement will be performed.
Note: Do not turn OFF the Sensor before the Sensor is
set to MONITOR mode, otherwise the teaching data will
be lost.
Automatic
selection
形F10-C20/C25/C30/C35/C50/C55 02.11.19 10:12 AM ページ 21