Installation
Section
2-2
64
2-2 Installation
2-2-1 Mountable
Units
The Loop Control Unit is mounted on the CPU Rack for the CS1 series.
Only the three adjacent slots on the CPU Unit can be used as the mounting
location.
Note
The Loop Control Unit cannot be mounted on the I/O Expansion Rack for the
C200H and the SYSBUS Remote I/O Slave Rack.
2-2-2 Mounting
Procedure
Follow the procedure below to mount the Loop Control Unit on the
Backplane.
1, 2, 3…
1. Lock the top of the Loop Control Unit onto the Backplane by the hook and
rotate the Loop Control Unit downwards as shown in the figure.
Backplane
Hook
2. Correctly slot the connector of the Loop Control Unit into the connector on
the Backplane.
3. Tighten the mounting screw on the bottom side using a Phillips
screwdriver. During this operation, the Phillips screwdriver must be held at
a slight angle, so leave enough space below each Rack for mounting and
removing the Units.