ModeSel = 01 (18-Bit Data)
23 22 21 20 19 18 17 16 15 14 13 12 11
10 9
8
7
6
5
4
3
2
1
0
Co
mm
and
po-
si-
tion
Compensation value (integer part) 18 bits
Compensation value (frac-
tional part) 6 bits
ModeSel = 10 (20-Bit Data)
23 22 21 20 19 18 17 16 15 14 13 12 11
10 9
8
7
6
5
4
3
2
1
0
Co
mm
and
po-
si-
tion
Compensation value (integer part) 20 bits
Compensation
value (fractional
part) 4 bits
Status Data
When you send a command position to the Galvo Scanner, the status data will be sent from the Galvo
Scanner to the CK3W-GC Unit.
For details on the status data, refer to the Galvo Scanner specifications.
Parity bits are added to the status data.
In order to check that communications are in progress successfully, use a user program to check
whether the parity is correct.
3-7-7
SL2-100 Interface
The SL2-100 Interface establishes communications for connecting the Galvo Scanner of SCANLAB
GmbH and the Controller.
This section describes the functions of the SL2-100 Interface.
Signal Descriptions
The SL2-100 Interface carries the XY-axis and the Z-axis signals that move the Galvo Scanner re-
spectively in the vertical and horizontal directions and in the height direction.
Name
Function
XY-OUT/ Z-
OUT
Data to be sent to the Galvo Scanner.
The data length is 20 bits for X, Y, and Z each.
Additionally, you can set the type of data to be received from the Galvo Scanner by sending a
control command.
XY-IN/ Z-IN
Data to be received from the Galvo Scanner.
Receives the data set by the control command.
The data length is 20 bits for X, Y, and Z each.
3 Configuration Units
3-76
CK3M-series Programmable Multi-Axis Controller User's Manual Hardware (O036)
Summary of Contents for CK3M Series
Page 6: ...Manual Structure 4 CK3M series Programmable Multi Axis Controller User s Manual Hardware O036...
Page 284: ...Appendices A 42 CK3M series Programmable Multi Axis Controller User s Manual Hardware O036...
Page 285: ...I Index I 1 CK3M series Programmable Multi Axis Controller User s Manual Hardware O036 I...
Page 287: ......
