Olivetti PF-P09, Service Manual

Page: 355 / 457

20. FAX ERROR Field Service Ver. 1.1 May 2011
312
TROUBLESHOOTING
20.3.2 Transmission
Code Possible Causes of Error.
0080 Can not detect any G3 signal within 35 sec. specified by ITU-T in phase B.
0081 Received DTC signal in transmission phase.
0082 Transmitting unit receives a signal other than DIS or DTC and DCN in phase B.
0083 Detected FSK signal, but can not receive any signal within 35 seconds.
0084 Detect DCN signal in phase B.
0085 Transmitting unit sending DCS 3 times consecutively, but each time responds with DIS/DTC.
0086 Detected responds signal other than DTC, DIS, FTT, DCN or CFR after sending DCS.
0087 Training attempt has failed because speed unit can not adjust to lower speed.
0088 Received DCN signal after sending out DCS signal.
008B Receiver’s protocol of DIS is received, but it is not compatible with our machine.
008D
Receiver’s protocol of DIS is received, but remote side can not receive document temporary,
may be cause by run out of paper or other reason.
008E Remote side CSI number not defined in machine one touch or speed dial directory.
008F Modem not ready to received V.34 data within 6 seconds after received CFR signal.
0090 Called side document not ready for our polling.
0091 Sending out DCS+TCF signal 3 times consecutively but no signal in response from receiver.
0092 Remote side disconnected within transmitting phase.
0093 Received DCN signal after sending out DCS signal for V.34.
0094 Time out during transmit ECM frame or RCP command.
0095 Wrong ID number when Polling RX.
0099 Remote side disconnect after primary channel.
009A Can not detect any signal after sending CI signal.
009C Received DCN after sending DTC in V.34 polling RX.
009D Remote side hang up before V.34 modem enter phase 2 state in V.34 polling RX.
009F Can not received any response from other side after sending PPS_EOM signal.
00A0 User stop or cancel transmission job.
00A1 Document JAM within transmission.
00AE Can not finished V.8 procedure or detect V.21 signal after CM signal within 30 seconds.
00AF Modem can not enter into control channel after TX side sending out RCP signal for V.34.
00B0 Can not received any command after our side retry there DCS signal in V.34 TX.
00B1 Can not finish V.8 procedure or detect V.21 signal after ANSam signal within 35 seconds.
00B2 Can not detect phase 2 signal after our side sending CJ signal within 30 seconds.
00B3 Can not detect correct V.21 or JM signal after sending CM signal.
00B4 Can not detect correct phase 2 signal within 25 second after CM/JM signal exchange.
00B5 Can not detect phase 3 signal after phase 2 within 25 seconds.
00B6 Can not detect phase 4 signal within 25 seconds after CM/JM exchange.
00B7 Can not detect phase 5 signal after phase 4 within 30 seconds.
00B8 Remote side disconnect after our side sending DCS signal in V.34.
00B9 Receive T.30 signal other than DIS, DCS, CFR after sending DCS signal in V.34.
00BA Can not received correct signal after our side sending DTC signal in V.34.
00BB Every time our side received DIS signal after sending DTC in V.34.
d-Color MF2400