Olivetti PF-P09, Service Manual

Page: 380 / 457

Field Service Ver. 1.1 May 2011 20. FAX ERROR
337
TROUBLESHOOTING
(76) Error code: 00F6
(77) Error code: 00F7
(78) Error code: 00F8
(79) Error code: 00F9
(80) Error code: 00FA
(81) Error code: 00FB
Definition Received incorrect response after sending EOR_EOP.
Solution 1. Change the machine setting to ECM OFF, then resend again.
2. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition After received ERR, our side can not received response after sending EOR_EOP
command.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Change the machine setting to ECM OFF, then resend again.
3. Boost the TX level of sender's machine.
4. Boost the machine TX level. <*1>
5. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition At phase D, transmitting units out EOR_EOM 3 times consecutively but receive no
answer.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Change the machine setting to ECM OFF, then resend again.
3. Boost the TX level of sender's machine.
4. Boost the machine TX level. <*1>
5. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Received incorrect response after sending EOR_EOM.
Solution 1. Change the machine setting to ECM OFF, then resend again.
2. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Received ERR signal after sending EOR_EOM.
Solution 1. Change the machine setting to ECM OFF, then resend again.
2. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Can not receive any response in RR response procedure after sending EOR_EOM.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Change the machine setting to ECM OFF, then resend again.
3. Boost the TX level of sender's machine.
4. Boost the machine TX level. <*1>
5. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
d-Color MF2400