Olivetti PF-P09, Service Manual

Page: 366 / 457

Field Service Ver. 1.1 May 2011 20. FAX ERROR
323
TROUBLESHOOTING
(49) Error code: 005E
(50) Error code: 0060
(51) Error code: 0061
(52) Error code: 0062
(53) Error code: 0063
(54) Error code: 0064
Definition Can not detect control channel signal after received RCP frame within 6 seconds.
Solution 1. Ask sender resend the FAX again.
2. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
3. Boost the TX level of sender's machine.
4. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition There are no bulletin files to be polled in V.34.
Solution 1. Polling TX is not available.
Definition Machine can not detect V.21 or V.8 signal within 35 seconds.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the TX level of sender's machine.
3. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Modem disconnect in phase D after our side sending out flags sequence in control
channel.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the TX level of sender's machine.
3. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Can not receive any flag sequence in control channel within 6 seconds in phase D.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the TX level of sender's machine.
3. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Definition Can not detect any control channel signal in phase D within 60 seconds even
through energy still on the line.
Solution 1. Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
2. Boost the TX level of sender's machine.
3. Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
d-Color MF2400