OHAUS T72XW AM, Instruction Manual

Page: 48 / 143

EN 40 7000 SERIES INDICATORS
Reset on
The resetting of auto printing or logging can be based on weight threshold or weight deviation values. Select Return
(the weight must return to below this value to reset) or Deviation (the weight must change more than this value to
reset) from the selection box and enter the weight value in the “Reset on” field.
If
both “Interlock” and “Automatic” settings are disabled, the “Reset on” field does not display.
If “Reset on” is set to Deviation, the “Threshold Weight” and “Motion Check” fields do not display.
Threshold Weight
The Threshold Weight is the value above which an Automatic logging or printing of data can/will occur. Threshold
Weight does not appear if “Automatic” is set to Disabled or if “Reset on” is set to Deviation.
Motion Check
Enable the motion check setting to prevent interlock and automatic log and print functions from resetting when the
scale is in motion below the “Reset On” return point. Motion Check does not appear if “Reset on” is set to
Deviation.
Scale Reset
To initiate a reset of the Scale branch, press the
ENTER key. If the reset was successful, a verification message
that reads “Reset Successful” displays If the reset was not successful, an error message that reads “Reset Failure”
displays. If the reset fails, try to initiate the reset again. If the reset continues to fail, contact a local OHAUS
CORPORATION representative for assistance.
Press the
LEFT navigation key to exit without resetting.
Scale reset does NOT include the reset of metrologically significant parameters
– scale type, approval, weight
units, capacity, increment, or calibration data. This data is reset only by performing a Master Reset.
3.5.2 Application
A detailed view of the Application branch is shown in Figure 3-11. This view indicates all the parameters in the
Application branch. Each of these setup parameters are described in this section.
www.
GlobalTestSupply
.com
Find Quality Products Online at: sales@GlobalTestSupply.com