Oce VarioLink 2221, User Manual

Page: 250 / 364

Utility mode
10
VarioLink 2221/2821/3621 10-67
Utility mode
Chapter 10
10.22 Specifying software switch settings (machine func-
tions)
By specifying the software switch settings (“Mode Selection”, “Bit Selection”
and “Hex Selection”), various machine functions can be changed to meet
your specific needs.
2
Reminder
Do not change any modes or bits other than those described in this man-
ual.
2
Note
When “Enhance Security” is set to “ON”, the software switch settings
cannot be changed.
Software SW settings
Examples of settings for “Bit Selection” (binary numbers) and “HEX Selec-
tion” (hexadecimal numbers) are shown below.
Parameter Description
Mode Selection The parameter to be specified is expressed as a three-digit
number. Use the keypad to type in the value.
Bit Selection The bits are the eight numbers that construct the mode sta-
tus. By specifying a binary number (0 or 1) for each of the bits
(0 through 7), a setting for each parameter can be specified.
HEX Selection Specify a setting for each mode as a hexadecimal number (0
through 9 and A through F). Bit setting “0011 0000” is ex-
pressed as the hexadecimal setting “30”.
Specify a mode setting by using either bits or hexadecimal
values.
Decimal
number “Bit Selection” setting (binary
number) “HEX Selection” setting (hexadeci-
mal number)
0 0000 0000 00
1 0000 0001 01
2 0000 0010 02
3 0000 0011 03
4 0000 0100 04
5 0000 0101 05
6 0000 0110 06