Oce CS9350, Manual

Page: 186 / 194

CS9350 User’s Guide
7-186
12 [****] Check Ink Printer cannot identify the ink
cartridge or ink pack
correctly. •Insert the ink cartridge or ink
pack again.
6.1.1 Replacing
ink cartridges
13 [****] S/C ReadErr Reading Smart chip has been
failed. Insert Ink cartridges again. If
Smart chip still cannot be
read, insert new Ink
cartridges.
6.1.1 Replacing
ink cartridges
14 [****] S/C Col.Err Ink cartridges are inserted in
wrong slots. Insert ink cartridges correctly
again.
6.1.1 Replacing
ink cartridges
15 [*] S/C Ink Err The ink cannot be used for
this printer. Contact your local Océ
representative.
6.1.1 Replacing
ink cartridges
16 [*] S/C CodeErr Inserted Ink cartridge is not a
proper one. Contact your local Océ
representative. —
17 [*] Broken Chip Smart Chip has been broken. Insert new Ink cartridges.
6.1.1 Replacing
ink cartridges
18 Full WasteInkTank The waste fluid tank is full.
(Stops operation)
Dispose of waste fluid.
6.3 Disposal of
waste fluids
19 Life Times
[Head]
The operational life of the
print head has almost expired.
(Continues operation)
Contact your local Océ
representative. —
20 Life Times
[Pump]
The operational life of the
pump motor has almost
expired.
(Continues operation)
Contact your local Océ
representative. —
21 Life Times
[CR Motor]
The life CR motor is almost
expired.
(Continues operation)
Contact your local Océ
representative. —
22 Life Times
[PF Motor]
The operational life of the PF
motor has almost expired.
(Continues operation)
Contact your local Océ
representative. —
23 [****] Change plug Time for replacing Connector
rubber of High-capacity pack
adapter (option). Replace Connector rubber.
“3.2 Replacing
connector rubber” of
High-capacity pack
adapter manual.
24 No connector cap Connector cap is removed
from the connector. Install Connector cap to the
connector of
Spectrophotometer on Print
head.
4.5 Using
spectrophotometer
25 Color measuring mode error
(Take Up Roll)
Media ejection mode is set to
“Take-up”. Change the setting to “Off”.
5.1.6 Output
Mode menu
26 Color measuring mode error
(Media detection)
Media detection menu is set to
“Off”. Change the setting to either
“Width” or “Top & Width”.
5.1.4 Media
Initial menu
27 Color measuring mode error
(Media width)
The width of the media
installed does not match the
color target to be measured. Remove the media currently
set, and set a correct color
target.
3.4 Loading
media
N° Display Description Remedy Reference