Oce CS9350, Manual

Page: 65 / 194

CS9350 User’s Guide
3-65
Each Adjust Patterns
Select and print one of the adjust patterns A to F and register the set value.
Follow the procedures below to adjust “Pattern A” only.
Step 1:
Display the Custom Adjust Print menu on the operation panel in the same way as in step 2 of
“3.6.2.1 Custom Confirmation Pattern”.
Step 2:
Press the [+] key or [-] key to select “Adj.4: Fine PatternA”.
Step 3:
Press the [Enter] key on the operation panel.
• “Warming Up”, and then “Warming Up Skip -> E” are displayed.
NOTE

To start printing during warming up, press the [Enter] key while “Warming Up Skip -> E” is
displayed.
4.4.7 Start Printing during Warm up
• An Adjust print pattern for print quality adjustment is printed after warming up.
• Regarding adjust print patterns, the same patterns are printed repeatedly on both edges and the
centre of the paper.
Step 4:
Check the both ends and the centre of the print result that printed with Adjust pattern, and
select the number from 1 to 7 that is not out of alignment.