Oce CS9350, Manual

Page: 180 / 194

CS9350 User’s Guide
7-180
(2) The media is crumpled during initialization
NOTE

If the media is jammed or torn, remove it according to “7.3 The media is jammed”.
(3) The wrong media size is set during initialization
N° Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the loading position of the media correct? Set the media correctly.
3.4 Loading
media
3 Is the media loaded at an angle? Set the media straight.
3.4 Loading
media
4 Are there any foreign materials such as paper
attached to the pressurizing roller? Clean the pressurizing roller.
6.2.2 Cleaning
the inside of the
printer
5 Is the printer used in an environment other
than the one specified, such as near an air
conditioner? Only use the printer in an environment that is
specified for use.
Installation
manual
6 Are you using folded, torn or rolled media? Replace the media.
4.2.2 Cautions
on handling media
N° Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the media loaded at an angle? Set the media straight.
3.4 Loading
media
3 When the media is set, does it curl upward? Straighten the media or set a new media.
3.4 Loading
media
4 Is the printer used in an environment other
than the one specified, such as near an air
conditioner? Only use the printer in an environment that is
specified for use.
Installation
manual
5 Are you using media that has been printed on
already? Use a new media.
4.2.1 Media type