NTT docomo Foma D900i, Manual

Page: 76 / 284

74
Making a Videophone Call (continued)
Basic
O
perations
Making/Receiving
Videophone
C
alls
•
Do not cover the antenna with your hand, so your FOMA terminal will have better reception.
•
When talking with the hands-free function set to on, be sure to keep your FOMA terminal from your ear. If
not, a loss of hearing or ear damage may occur.
•
If you make a phone call to “110 (police)”, “119 (fire station/ambulance)”, or “118 (coast guard)” with the
Videophone, the call cannot be connected. Set the automatic voice call redialing (see p.89) to “ON” and the
call will be tried again as a voice call and then connected.
•
During a videophone call, you cannot make another voice or Videophone call. Alternatively, you cannot use
any i-mode service, send or receive mail, send short message (SMS), and receive Message R/F. You
cannot use packet communication and 64K data communications. (However, you can receive a Short
Message (SMS).)
•
The videophone call time is accumulated and displayed not as the voice call time, but as the digital call
time (see p.135).
•
Even if you use an alternate image for the videophone call and the call is made only with voice, not voice
call charge but digital communication charge starts.
•
Reception is unstable if you make or receive a call while moving. Due to the characteristics of digital
communication, a call could be suddenly interrupted. Faint signals may prevent you making a call even if
the “
圏外 ” indicator is not displayed. It is recommended that you select a location with good reception
(when you are indoors, preferably close to a window where the reception level is ).
•
If the battery runs down during a call, you hear an alarm tone and your FOMA terminal is disconnected
after about 20 seconds.
•
When the battery is discharged and “ 充電してください (charge battery)” appears during a videophone call,
your image or alternate image during a call are sent to the other party’s terminal, and the call is continued.
•
If a videophone call cannot be connected, a message indicating the reason appears on the screen. The
displayed reason may differ from the actual conditions of the receiver depending on the type of phone the
receiver uses or whether the receiver subscribes to the network service, however.
N o t e
•
When the voice of video is failed to be sent or received during Videophone communication, the connection
is not recovered automatically. Make a videophone call again.
•
You can end your call or put it on hold by closing your FOMA terminal (see p.133).
Displayed message
番号をご確認の上おかけ直し下さい
Check the number and redial
お話中です Busy
ドライブモード中です
Drive Mode
接続できませんでした
Cannot be connected
An unused phone number is dialed.
The line is busy.
The receiver’s phone is in a place where the
signal does not reach or turned off.
The receiver’s phone is in Drive Mode.
電波の届かない所にいるか電源が切れています
The signal does not reach or power is off
This message appears for a reason other than the
above.
Reason
* You can set from the submenu. Follow Step 1 in Making a Videophone Call (see p.73)
•
When you make a videophone call to the terminal which does not support Videophone, or the other party’s
terminal is out of area or turned off, it cannot be connected. When you make a videophone call to the terminal
which does not support Videophone and the Auto Redial by Voice is on (see p.89), the call is terminated
before connected and redialed as a voice call. However, it may not operated if you make a call to the ISDN
Videophone which does not support an ISDN synchronous 64K or PIAFS access point, 3G-324M (see p.72)
(as of May 2004
)
, or if you make a call to a wrong number. Note that the call charge may be added.
•
The 32K Videophone communication function is provided for connecting a device such as a PHS terminal
for which 64K videophone calls may be unavailable depending on the network condition. When you make
a 64K videophone call, but the receiver is in a 32K communication environment, the Videophone call is
automatically changed to a 32K videophone call and redialed.
* The digital communication charges at 32K and 64K are the same.
•
When the call has been connected to a videophone call, Auto Redial by Voice is not performed.
•
The call redialed by voice is charged not as a digital communication but as a voice call.
The order of redialing when the videophone call is not connected
Set Communication
Speed*
64K
64K
ON
OFF
64K
64K
32K
32K
Voice
—
32K
32K
ON
OFF
32K
32K
Voice
—
—
—
Set Auto Redial by
Voice (see p.89)
Dialing
Redialing
First Second
Set Communication
Speed* Set Auto Redial by
Voice (see p.89)
Dialing
Redialing
First Second