NTT docomo Foma D900i, Manual

Page: 148 / 284

146
Customizing the Standby Screen (continued)
Advanced
Operations
Customizing
D
isplay
and
K
ey
Settings
5 Change the display format, etc. as needed.
■ To change the clock format (12/24-hour system)
1
Select “2. 12/24h切替 ” from the submenu.
■
To change the image-display format
The following image-display formats can be selected
■ To change the position of the clock time and the date
1
Select “4.
時計位置調整
” from the submenu.
2
Use to adjust the position and press (
選択
).
•
When the large clock is displayed, only the position of the clock time can be changed. The
position of the date cannot be changed.
•
When the small clock is displayed, changing the position of the clock time also changes the
position of the date.
6 Press ( 選択 ).
The Standby screen is set.
4 Use to select a type of clock.
•
When you press , the display changes in the following order: Digital clock (large) → Digital
clock (small) → No clock.
■ To play video/i-motion, animation or Flash movie
1
Select “1.
再生
” from the submenu.
•
To adjust the sound volume of video/i-motion, use to select the sound level and press
(OK).
•
To stop playback of video/i-motion, press ( ■ ). Alternatively, you can press or
to end playback. (Playback is continued even when you close the FOMA terminal
during playback.)
To stop playback of the animation and Flash movie in the middle, press ( 停止 ).
Alternatively, you can press , , , ~ , or to end playback.
•
A Flash movie will end when no operation is performed for about 75 seconds.
•
The sound effect of a Flash movie does not sound. You cannot perform operations in a
Flash movie such as item selection.
•
A saved Flash movie may be viewed differently from that displayed on a site. The Flash
movie may not be played back even if it is played back correctly on a site.
•
To play video/i-motion, a prompt appears while Manner Mode or Drive Mode is set. To play
the video/i-motion with sound, select “ はい ”, to play without sound, select “ いいえ ” and
press (
選択
).
•
When there is a voice call during playing back a Flash movie, the message that indicates
the image is wrong may appear during ending the call.
In this case, if the Flash movie is played back again, it may be played back correctly.
1
Select “3.
全画面表示
(full screen)” from the submenu.
To switch the screen from the full-size display to the center display, select “3. 中央表示 (center
display)” from the submenu.
中央表示
Center display
全画面表示
Full screen
When an image is wider than the display area, the image is reduced and
displayed. In addition, when the image is taller than the display area, the
top and bottom are truncated and displayed accordingly.
When the image is larger than the display area, it is the same as for “
中央
表示 ”. When the image is smaller than the display area, the width or height
of the image is enlarged to the display area and displayed accordingly.
However, it is twice the maximum magnification of this. (Even if enlarged, it
may be displayed smaller than screen size).