Chapter 2 CPT7 Installation
CPT7 and CPT7700 Installation and Operation User Manual v12
30
Figure 5: Typical Installation of a CPT7700 System
Power can be connected to
either
the IO1 or IO2 port.
Do not
connect a power supply to both ports.
Complete the following steps to set up your CPT7 system.
1. Mount the GNSS antenna.
See
on the next page for details.
2. Mount the CPT7.
See
on the next page for details.
3. Connect the primary GNSS antenna to the RF1 port.
Connect the secondary GNSS antenna to the RF2 port (
CPT7 only
).
Use an SMA torque wrench to tighten the connection to 0.9 Nꞏm (8 in-lbs) maximum.
The CPT7 su5 VDC (200 mA maximum) to the antenna LNA through the center conductor of the
antenna cable. See
on the next page for more information.
4. Connect the Event input and output signals (optional).
See
Connect I/O Signals to the CPT7
on page 38 for details.
