3
Getting Started
44
Pulse Laser Station NPL-302 Series Instruction Manual
To change the settings defined in a target set, highlight the target set in the list.
Then press the
Edit
softkey.
Type
Prism/N-Prism
Const
–999 to 999 mm
HT
–9.990 to 99.990 m
Entering a field note
To enter a field note, press
[HOT]
to display the
HOT menu. Then either press
[4]
, or select
Note
and press
[ENT]
.
This function can be used at any time on any
observation screen.
Each note can be up to 50 characters.
The note is stored as a CO record in the raw data.
To display a list of previously used notes, press
the
Stack
softkey. The stack stores the last 20
notes.
Use
[^]
or
[v]
to highlight a note in the list. Then
press
[ENT]
to select the note.
HT can be left blank in the target set. If you leave it blank, the current HT value is
always applied to the measurement.
When a target set is selected, the Type and Const values are copied to both
[MSR1]
and
[MSR2]
settings, and to the measurements in Qcode. If you have specified a
value for HT, this value is also copied to the current HT.
Summary of Contents for NPL-302 Series
