NEC Express 5800, User Manual

Page: 655 / 719

Operation and Maintenance
655
Checking Test Status
Use <stat> command to check the progress of the test. To check the detailed status for each
test, use <statv> command. This command shows the number of executed times and
progressing status of each time for each test.
The following is an example of screen using the commands.
• One of the following three statuses is displayed in “Status.” This is the status of TeDoLi
itself.
Idle status : Status before starting the test. Or the status after
the completion of test.
Executing status : Status that the test is being executed.
Waiting for
Termination status : Status that waiting for the completion of the test.
• Elapsed time of the test being executed (elapsed time from entering <exec> command) is
displayed in “Time.” The time is updated until all the tests are completed.
• “Total of tests” shows the total number of tests. Test types are sorted as follows
depending on the executed test results.
Pass: : Number of tests ended normally
Failure : Number of tests ended with error
Warning : Number of tests ended with warning (# This is an information expanded
in the future and is not supported as of yet).
• There are two procedures to specify the test with <statv> command.
Specifying “Test device number” : Specifies the test device number in “Num” row.
Specifying <all>
: Specifies all the devices.
• “Test Count” shows the number of executed test. This item shows “1” immediately after
starting the test.
• “Progress” shows the degrees of progress of the test in the test round. This is not the
degree of progress for the entire rounds.
TeDoLi> stat
Status : Executing
Time : 000:00:44
Total of tests : 15
Running : 15
Pass : 0
Failure : 0
Warning : 0
TeDoLi> statv 14
----------------------
BM/MB/PCI8/Port1(eth0)
----------------------
Test Count : 74
Progress : 49%