NEC Express 5800, User Manual

Page: 532 / 719

532
Execute the command such as below when updating the BIOS.
-> load -source tftp://192.168.1.1/0001A052_R828.rom -oemnecfiletype bios
Execute the command such as below when restoring the SG information.
-> load -source tftp://192.168.1.1/bmcsg1.zip -oemnecfiletype sg partition1
・
reset
The format of reset command is shown below.
reset [<options>] [<target>]
This command reboots(power cycle) of the partition(server). Add “-f” option if it is needed to be
powered off and on compulsory.
Below is the example.
-> reset partition1
IMPORTANT:
•After updating the BIOS, the new BIOS is started up at the next
DC power ON. The management firmware is not necessary.
IMPORTANT:
•Restoring SG information is executed for each partition
(server).
•The management firmware is automatically reset and the new
SG information is available after restoring the SG information.
HINT:
•SG,System Genaration, means the configuration settings for
the system.
IMPORTANT:
•There is a risk to break the OS disk if the power is off and on
compulsory during OS is operationg.
HINT:
•The power cycle means the behavior that the power is ON
automatically after the power OFF. Reboot means the behavior
that the power is ON after the power OFF.