Viper TX – Operation Instructions
10
AP-75710, Rev. 1.1, 09/01/2008
1.4 IMPORTANT SAFETY INSTRUCTIONS
General safety instructions that must be observed to use the equipment safely are explained below.
¾
Do not place the printer in the following areas. Doing so may result in the printer tipping or falling over
and causing injury.
o
Unstable
surfaces
o
Sloping
floor.
o
Areas subject to vibration by other equipment
¾
Do not stand on or place heavy objects on your printer. Doing so may result in the printer tipping or
falling over and causing injury.
¾
Do not cover the ventilation hole of your printer with cloth, such as a blanket or table cloth. Doing so
could obstruct ventilation and cause fire.
¾
Do not place the printer in humid and dusty areas. Doing so may result in electrical shock or fire.
¾
Do not use a damaged power cable. Doing so may result in electrical shock.
¾
Do not attempt to plug in electrical plugs with wet hands. Doing so may result in electrical shock.
¾
Do not connect earth cables in the following areas.
o
Gas
pipes
→
Doing so may cause fire or an explosion.
o
Earth terminals for telephone line or lightning rod
→
Doing so may cause a large flow of voltage if
lightning occurs.
o
Water pipes or faucets
→
If there is a plastic part in the pipe, the earth will not work properly.
¾
Do not insert or drop metal or inflammable objects into openings, such as ventilation outlets. Doing so
may result in electrical shock and fire.
¾
Stop using your printer if a liquid is spilled into it. This may cause electrical shock or fire. Turn the
printer off as soon as possible, unplug the power cord, contact your local MUTOH dealer.
¾
Be sure to use the attached cable. Otherwise, electrical shock or fire may occur.
¾
Be sure to use the specified voltage (AC 100 V to 120V, or AC 220V to 240V). Otherwise, electrical
shock or fire may occur.
¾
Use electricity directly from a power outlet (AC 100 V to 120V, or AC 220V to 240V). Do not put many
loads on one electrical output. Otherwise, heat may be generated and cause fire.
¾
Be sure to use an outlet with an earth terminal and use the terminal correctly. Otherwise, electrical
shock or fire may occur.
¾
Follow the instructions below when handling the power cable.
o
Do not modify the cable.
o
Do not put heavy objects on the cable.
o
Do not bend, twist or pull the cable.
o
Do not wire the cable near equipment that generates heat.
¾
Follow the instructions below when handling the power plug. Otherwise, fire may occur.
o
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it will go.
¾
Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or paint
peeling from the casing.
¾
Be careful not to pinch your fingers when opening and closing the front cover.
¾
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin.
¾
Do not touch the roll feed, this can result in decreased print quality.
¾
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
Downloaded From ManualsPrinter.com Manuals
