Viper TX – Operation Instructions
28
AP-75710, Rev. 1.1, 09/01/2008
3.4.3 Level the printer
PART 1 : Level the printer in Y – direction
Step 1 :
Position the printer in its final position.
Step 2 :
Turn down all feet of the printer stand (NOT those of the UW/W 100) with an equal pressure until
the wheels come off the ground. Use a forkspanner.
1 = Foot
2 = Wheel
Step 3 :
Place the level on the left and right side of the printer’s stand and level the printer sides by
turning the feet under the stand. The image below shows the Y – leveling direction.
PART 2 : Level the printer in X – direction
Step 1 :
Position the level on the print platform.
Step 2 :
Turn the left and right weight supports an equal amounts of turns. See image below.
Notes
•
Make sure to turn the left and right weight supports an equal amount of turns, otherwise the levelling in
Y direction was useless.
Downloaded From ManualsPrinter.com Manuals
