Viper TX – Operation Instructions
43
AP-75710, Rev. 1.1, 09/01/2008
3.6.2 Connecting the foot switch for the pressure roller
If the pressure roller needs to be raised or lowered, it is possible to control this motion from the foot switch,
instead of doing so at the operation panel.
Caution
•
When handling the foot switch, be aware of the following:
o
Do not place anything heavy on the foot switch.
o
Do not bend the cable of the foot switch with force and do not pull.
o
Do not place the foot switch near thermal devices.
Install the foot switch according to following procedure.
Step 1 :
Make sure that the power of the unit is OFF.
Notes
•
When the operation panel is in the following condition, the power is ON. Press the key again to turn
the power OFF.
o
The POWER lamp is lit (green).
Step 2 :
Connect the foot switch cable connector to the foot switch connector at the rear of the unit and fix
into place.
1 = Foot switch connector
2 = Foot switch cable
Step 3 :
Place the foot switch on the floor under the stand.
Downloaded From ManualsPrinter.com Manuals
