Viper TX – Operation Instructions
36
AP-75710, Rev. 1.1, 09/01/2008
Step 2 :
Draw a line.
Step 3 :
Slide the strip (1) to position 2 as indicated on the image below.
1 = Synthetic paper strip
2 = Loop
3 = Core
4 = Pressure rollers
Step 4 :
Place the adjustment plate onto the strip and slide it against the pressure rollers.
Step 5 :
Pull the strip so there is an equal tension.
Caution
•
Don’t pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
•
Make sure that you have an equal tension on the left and right of the strip.
Downloaded From ManualsPrinter.com Manuals
