Viper TX – Operation Instructions
35
AP-75710, Rev. 1.1, 09/01/2008
Step 4 :
Check if the edges of the loop are aligned on each other.
Step 5 :
Slide the end of the synthetic paper strip (1) under the pressure rollers (4) in position 1 of the
printer until the synthetic paper strip (1) is a little tensioned.
1 = Synthetic paper strip
2 = Loop
3 = Core
4 = Pressure rollers
Caution
•
Don’t pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
•
Make sure that you have an equal tension on the left and right of the strip.
P
ART
2
:
D
RAWING THE CONTROL LINES
Step 1 :
Standing at the front side of the unit, place the adjustment plate onto the strip and position it
against the pressure rollers as indicated on the image below.
Downloaded From ManualsPrinter.com Manuals
