Viper TX – Operation Instructions
11
AP-75710, Rev. 1.1, 09/01/2008
¾
When handling the foot switch, be aware of the following:
o
Do not place anything heavy on the foot switch.
o
Do not bend the cable of the foot switch with force and do not pull.
o
Do not place the foot switch near thermal devices.
¾
When handling ink cassettes, be careful that ink does not get in your eyes or on your skin. However, if
this happens, flush imfabrictely with water. Otherwise, your eyes may become congested or inflamed
slightly. If you feel discomfort, consult a doctor imfabrictely.
¾
Be careful not to pinch your fingers when opening and closing the cover of the ink compartment.
¾
Follow the instructions below when connecting the network interface cable. Otherwise, electrical shock
or fire may occur.
o
Do not touch the connector.
o
Do not connect the network cable connector that is not the same specification to the interface board.
¾
Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunctioning in
the printer.
¾
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid will leak out and
malfunction in the product.
¾
Do not touch the cleaning wiper or the head cap unit with your hands while cleaning the cleaning wiper.
Doing so may result in poor head cleaning because of oil on your hands. Always wear protective gloves.
¾
Do not tilt the printer, stand it against a wall or turn it upside down. Doing so may cause ink to leak
inside the printer. Movement after transport is also not covered by the warranty.
¾
When installing options, do not touch the elements on the circuit board. The elements on the boards can
be very hot and can cause burns.
¾
Have four or more people unpack and assemble the printer.
¾
Have two or more people transport the printer.
¾
Ensure that the plug has been disconnected from the power socket when it is not to be used for a long
time.
¾
Earth wires must be connected to wires or terminals that fulfil the conditions below.
o
Earth terminals of power sockets
o
Earth wires with copper morsel that is at least 650 mm under the ground
¾
Keep the printer horizontal during transportation.
¾
The unit is delivered / shipped with special shipping liquid. This to prevent air coming into the ink supply
system. Make sure that air never comes into the ink supply system.
¾
When using the rinsing bottle, be careful that only parts that have to be cleaned become spilled with
water. These parts are described in this manual
¾
Be sure to do the following before attaching options.
o
Turn the printer off.
o
Unplug the power cord from the socket.
o
Unplug cables connected to the printer. Otherwise, damage to the printer or your computer may
occur.
o
Remove electrostatic charge from your clothes and body by touching the metal parts of the printer.
o
Electronic components such as the memory may malfunction if exposed to an electrostatic charge.
¾
The equipment that you bought has required the extraction and use of natural resources for its
production. It may content hazardous substances for the health and the environment.
In order to avoid the dissemination of those substances in our environment and to diminish the pressure
on the natural resources, we encourage you to use the appropriate take-back system. Those systems
will reuse or recycle most of the materials of your end life equipment in a sound way.
If you need more information on the collection, reuse and recycling systems, please contact your local or
regional waste administration.
Downloaded From ManualsPrinter.com Manuals
