Note:
Attach plate (6) only to the upper part of the openings.
3.
Secure the plates (6) with screws (4) and washers (5) at the lateral openings on both sides of the flywheel
housing and tighten to the specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M16
Tightening torque
250 Nm +25 Nm
4.
Screw locknut (2) onto screws (1) up to the end of the thread.
5.
The long end of retainer (3) must face downwards. Insert retainer (3) through the openings of plate (6).
Note:
Retainer (3) must lock only the flywheel, not the ring gear.
6.
Install screw (1) into the bore of retainer (3) until the retainer (3) is locked in position.
Note:
The screw (1) must be tightened alternately on both sides of the flywheel housing.
7.
Tighten screw (1) to specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M10
Tightening torque
30 Nm +3 Nm
8.
Fit locknut (2) of screw (1) on plate (6) and secure.
Removing the transport locking
device from driving end (KS)
1.
Release the locknuts (2) on both sides of the
flywheel housing, remove screw (1) and take
off retainer (3).
2.
Remove screws (4) and take off with wash-
ers (5) and plate (6).
3.
Store the removed parts of the transport
locking device carefully for possible reuse.
30 | Transport | MS15065/01E 2019-01
TIM-ID: 0000035999 - 005
