9 Operation
Maschinenfabrik Reinhausen GmbH 2021
81
7817454/02 EN
TAPCON
®
230 Expert
9.1.7.1 Linking functions
You can link the
General purpose input
or
Generic SCADA command
events
with device functions. This allows you to remotely control the device using
digital inputs or commands via the control system (SCADA).
To establish the link, you have to enter the corresponding event number in
the desired parameter.
Note that you can only enter the event numbers of the
General purpose in-
put
or
Generic SCADA command
events.
If you enter event number 500, the link is disabled.
ü
The desired event number is known [
1. Go to
Settings > Parameters > System > Link functions
.
2. Select the desired parameter.
3. Enter the desired event number.
4. Press the
Accept
button to save the modified parameter.
Master parallel operation method
If the assigned event is active, the device activates the master parallel oper-
ation method.
Follower parallel operation method
If the assigned event is active, the device activates the follower parallel oper-
ation method.
Automatic tap synchronization parallel operation method
If the assigned event is active, the device activates the automatic tap syn-
chronization parallel operation method.
Independent regulation
If the assigned event is active, the device activates the independent regula-
tion independent mode.
Blocking
If the assigned event is active, automatic control is blocked.
High-speed return
If the assigned event is active, the device activates high-speed return. With
high-speed return, the device ignores the set delay time of automatic voltage
regulation.
