Mitsubishi Electric 13JV28, Reference Manual

Page: 30 / 378

28
3 AnyWireASLINK
3.1 Detecting Devices Supporting iQSS Automatically
• The system configuration cannot be detected if an error occurs on the AnyWireASLINK master module.
Take corrective actions and perform an automatic detection of connected devices again.
• Error information is displayed in the "Output" window when an error occurred.
Double-click it and correct the error at the jumped destination.
• When a module which is not a device supporting iQSS is detected, it is displayed as shown below:
"Module with No Profile Found"
"General Module"
■
Detection methods of a system configuration
The system configuration of AnyWireASLINK can also be detected by either of the following operations.
• Click the [Detect Now] button in the "AnyWireASLINK Configuration" window.
• Select [Online]
 [Detect Now] in MELSOFT Navigator. (FXCPUs do not support this function.)
For the operation methods of MELSOFT Navigator, refer to the following manual.
(

Let's start iQ Works Version 2)
5.
When an automatic address detection is required, select the
"Execute Detect Now after Address Auto-recognition"
checkbox, then click the [Yes] button.
For a case in which an automatic address detection is required,
refer to the following manual.

MELSEC-Q/L AnyWireASLINK Master Module User's Manual
The actual system configuration is displayed in the
"AnyWireASLINK Configuration" window.
6.
Select [AnyWireASLINK Configuration]  [Close with Saving
the Setting] in the "AnyWireASLINK Configuration" window.
The setting in the "AnyWireASLINK Configuration" window is
saved and completed.
1. Check
2. Click
List of modules
Device map area
Output window
Select