![background image](http://html1.mh-extra.com/html/mircom/flex-net-phase-ii/flex-net-phase-ii_application-manual_1805867040.webp)
40
Firmware Loading
6. Navigate to the HyperTerminal menu bar and select Transfer, then select Send File. A
Send File window appears.
7. Specify the location of the binary file that contains the new audio card firmware by
entering the file path or by pressing the Browse button and searching for the file. Set the
Protocol to "Ymodem" and press Send.
8. When the "flexnet>" prompt reappears type in "reset" and press enter.
12.3 Quad-Loop Adder Firmware
1. Connect the serial cable from the PC to the QX-5000N RS-232 Debug Tool and connect
the 8-pin head to the P5 RS-232 Debug port on the quad loop adder board. Ensure that
the keyed extrusion on the connecter lines up with the one on the port.
2. Run the HyperTerminal software on the PC.
3. In the HyperTerminal start up prompt set the correct communications port and select a
baud rate of 115200.
4. Reset the processor on the quad-loop adder by shorting the reset jumper JW1 on the
quad-loop adder main board. The jumper only needs to be shorted momentarily, it
should be normally open. During the reset process press any key in HyperTerminal to
enter the Flex-Net shell.
5. Input the following set of commands after the "flexnet>" prompt appears and press enter
after each one: "sf probe 1", "sf erase 0x200000 0x600000", and "run sflash".
6. Navigate to the HyperTerminal menu bar and select Transfer, then select Send File. A
Send File window appears.
7. Specify the location of the binary file that contains the new quad-loop adder firmware by
entering the file path or by pressing the Browse button and searching for the file. Set the
Protocol to "Ymodem" and press Send.
8. When the "flexnet>" prompt reappears type in "reset" and press enter.
12.4 RAXN-LCD and RAXN-LCDG Firmware
1. Connect the serial cable from the PC directly to the main board.
2. Run the HyperTerminal software on the PC.
3. In the HyperTerminal start up prompt set the correct communications port and select a
baud rate of 115200.
4. Reset the processor on the quad-loop adder by shorting the reset jumper JW1. The
jumper only needs to be shorted momentarily, it should be normally open. During the
reset process press any key in HyperTerminal to enter the Flex-Net shell.
5. Input the following set of commands after the "flexnet>" prompt appears and press enter
after each one: "sf probe 1", "sf erase 0x200000 0x600000", and "run sflash".
6. Navigate to the HyperTerminal menu bar and select Transfer, then select Send File. A
Send File window appears
7. Specify the location of the binary file that contains the new annunciator firmware by
entering the file path or by pressing the Browse button and searching for the file. Set the
Protocol to "Ymodem" and press Send.
8. When the "flexnet>" prompt reappears type in "reset" and press enter.
Summary of Contents for Flex-Net Phase II
