110
Appendix B: Using the Configurator
Loop Detail
The list view displays the hard wired (Conventional) circuits or addressable devices of a Loop,
when that loop is selected in the tree. The same view is also used for an audio controller's
loops: phone and voice lines (inputs) and amplifiers (outputs). The base set of columns is the
same for all, but there are some Product and Loop Type dependencies.
Some columns containing advanced or internal information are normally hidden. They are
listed as Visible / No in the following table. Other columns are conditionally visible.
Name
Visible
Description
Addr
Yes
For regular addressable devices, the displayed address is
the same as device address. For conventional circuits
display adder & circuit on adder.
Lp
No
Loop Number
Lp Addr
No
For conventional, its relative position on the loop. For
addressable, the actual address setting.
Ckt No
No
An internal, sequentially assigned number. One set for
inputs, another for outputs.
Device
Yes
Conventional - fixed, depending on the circuit adder. See
Add Circuit Adders.
Addressable - chosen when Adding Device(s). Can be
edited conditionally. For example, a Photo Detector can be
changed to other types of detector, a Relay Opt module
can be changed to a Supv. Opt module. Other changes
can only be achieved by deleting the device and adding
another.
Type
Yes
The process Type of the Device. Can be edited (combo
box). The list of Types shown in the combo box will
depend on the Device. E.g. Device Relay Opt Module can
be assigned Relay, Signal or Strobe.
Code
No
Applies only to input zones.
Sens Lvl Pre
On Addressable
Loops.
The Pre-alarm (or for some device types the trouble)
sensitivity level. Optional.
Sens
On Addressable
Loops.
The alarm level 1 sensitivity of the sensor. Displays a
combo with sensitivity in appropriate units for the device
type. Required for sensors.
Sens Lvl 2
On Addressable
Loops.
The alarm level 2 sensitivity of the sensor. Displays a
combo with sensitivity in appropriate units for the device
type. Optional.
Sens Lvl 3
On Addressable
Loops.
The alarm level 3 sensitivity of the sensor. Displays a
combo with sensitivity in appropriate units for the device
type. Optional if Lvl2 specified.
Sens B Lvl
Pre
On Addressable
Loops, if after
hours specified.
The after hours and night time Pre-alarm (or for some
device types the trouble) sensitivity level. Optional.
Summary of Contents for Flex-Net Phase II
