106
Appendix B: Using the Configurator
Input / Output Circuit Summary
The Job Tree always contains an Input Summary and Output Summary item. Select either of
these items to see a list of all of the circuits on the job.
On products that support them, this list may include Correlatable Switches. These will not
have a value in the Loop and Address columns.
LedGrp
No
An internal number, allocated when a LED is assigned a role
other than un-assigned. In the case of Linked Items, multiple
LEDs can share the same LedGrp and hence the same LED
Definition, behaviour and correlations.
Type
Yes
Initially unassigned this is the Type of display item. The values in
the combo box depend on the Adder/Frame type.
Assignment
Yes
Dependent on the Type.
Node Group
Yes
Applies only to common control switches. The column displays
the Node Group to which the common control operation is to be
limited. Global means that the operation is system wide and is
the default. If the user has created Node Groups, then one of
those groups can be chosen. The common control then applies
only to the member nodes of that group.
Code
Conditional
If the Type is Zone Sw (correlateable switch) and Coded System
is specified, then Code is displayed and editable as for an Input
Circuit.
F1
Yes
If the item is some form of switch (Bypass, Slide Switch) etc,
then this flag column can be set to ER (enable required) or none.
F2
Yes
For Bypass ands Manual Switches, this flag can be set to AR
(Aux Reset Required). For Correlatable Switches it can contain
NS (Non silenceable)
F3
Yes
For Correlatable Switches this flag can contain GA (2nd stage,
GA device). For Bypass and Manual Push Switches it can
contain SR (System Reset Required).
Tag 1
Yes
Except for Common Controls, System Status and Man Ena, a 20
character tag can be entered. It will be used to identify the
control in messages, etc. For some Type/Assignment
combinations the tag is generated and cannot be editted.
Tag 2
Conditional
Correlatable Switches (being analogous to Input Zones) accept
a second line of 20 characters.
Name
Visible
Description
Summary of Contents for Flex-Net Phase II
