104
Appendix B: Using the Configurator
Line 1
•
Dial Using
•
Tone/Pulse
•
Wait
•
Check to wait for dial tone before dialling
Line 2
•
Dial Using
•
Tone/Pulse
•
Wait
•
Check to wait for dial tone before dialling
Report Priority
•
Alarm
•
Choose one of the two accounts to use to report Alarms
•
Supv
•
Choose one of the two accounts to use to report Supvisory alerts
•
Trouble
•
Choose one of the two accounts to use to report Troubles
Timers
•
AC loss delay
•
0-20 hours
•
Line 2 Cellular Test
•
Check this box to indicate that Line 2 dials a cell phone. Use the Spin box to
specify the day of the month (1 - 28) for the cell phone test.
•
Auto test at
•
Use this spin box to set the time for a daily test of land lines.
Dialer
•
Line Retries
•
Use this Spin Box to specify the number of retries to make (5-10)
•
Rings
•
Use this Spin box to specify the number of rings when dialing in to configure.
Warning: if set to zero the next dial in session will not be able to connect.
•
Mode
•
Choose between DACT and UDACT
•
Enable
•
Uncheck this box if you wish to set the dialer to the disabled state when you
send the job to the panel. If you receive a job from the panel when the dialer
was temporarily disabled then this check box will be un-checked. The dialer is
enabled by default.
Summary of Contents for Flex-Net Phase II
