Minicom SMARTRACK 116 IP, User Manual

Page: 90 / 92

SNMP Events Table
90
| Smart 108/116 IP
9 SNMP Events Table
The following table lists all recorded events.
Event Text Code Comment
System Boot 1010 Reported upon device boot-up.
Server Busy ask
for disconnect. 1030 Attempt to connect when another user is already connected. The second
user has permission for takeover; sent before the second user actually
takes over the session.
User login
succeeded 1040 On every successful user login to the device.
Login failed wrong
user name or
password 1050 Login failed due to wrong user name or password.
Login not
succeeded server
busy 1060 Login denied because a user with higher permission is connected
(takeover not allowed).
Logout 1070 User Logout (end of remote access session).
Disconnected by
another user 1110 Takeover has been successfully performed; the previous user has been
disconnected.
Hardware Failure 1200 Device internal hardware failure. Try disconnecting any other attached
device and reboot. If problem persists, contact technical support.
Hard reset power
cycle command 1220 Power cycle command issued; only relevant when a special power-cycle
product is attached to the device (for exmple, KBPower).
Viewer login 1230 User connected in view-only mode (while another user is connected in a
regular session).
Viewer logout 1240 User connected in view-only mode has disconnected.
Global access
disabled 1250 Device has been blocked for access by an administrator; remote access
is disabled until the device is unblocked.
Block User
Account 1260 User blocked due to too many login attempts; failure per policy in
configuration.
Successful User
Login 2010 Successful User Login. CONF_USER_EVENT_LOGIN_SUCCEEDED
Login is not
successful –
wrong user access
level. 2020 Login is not successful – wrong user access level.
CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_WRONG_LEVEL