2.4.2
Replacing the Bracket
The rails in your hardware kit come assembled with s
are appropriate for a rack depth of
your needs, proceed to connect the SmartRack 116 IP to the rack (see Section
If you require a rack depth of
longer brackets, as described in the following procedure.
The illustrations in the following procedure show
the SmartRack 116 IP. The connections are the same for the other side..
To replace the bracket:
1. Loosen the seven screws
Figure
2. Remove the six screws
Figure
3. Remove the rear bracket
Figure
4. Insert the long bracket into the rail
Tighten at least 2~3 screws along the length
Rack Mounting SmartRack 116 IP
Replacing the Bracket
rails in your hardware kit come assembled with shorter brackets. These brackets
are appropriate for a rack depth of 504 ~ 614 mm. If this rack depth is suitable for
your needs, proceed to connect the SmartRack 116 IP to the rack (see Section
If you require a rack depth of 905 ~ 990 mm, replace the shorter brackets with
longer brackets, as described in the following procedure.
in the following procedure show the connections to one side of
the SmartRack 116 IP. The connections are the same for the other side..
Loosen the seven screws.
Figure 11 – Loosening the Seven Screws
Remove the six screws (from the bottom and top edges).
Figure 12 – Removing the Six Screws
Remove the rear bracket.
Figure 13 – Removing the Rear Bracket
Insert the long bracket into the rail, and then adjust the bracket to fit your cabinet.
Tighten at least 2~3 screws along the length that you need.
Installation
Mounting SmartRack 116 IP
User Guide
|
19
horter brackets. These brackets
. If this rack depth is suitable for
your needs, proceed to connect the SmartRack 116 IP to the rack (see Section 2.4.3).
, replace the shorter brackets with
the connections to one side of
the SmartRack 116 IP. The connections are the same for the other side..
then adjust the bracket to fit your cabinet.
Summary of Contents for SMARTRACK 116 IP
Page 92: ...201204210 933213_EN...
