MIMAKI JV400-130SUV, Operation Manual

Page: 11 / 194

Safety Precautions
x
1
2
3
4
5
6
Warning
Notes on UV LED
• Do not use the UV irradiation device in an ambience with a possibility of catching fire (gasoline, combustible gas spray,
thinner, lacquer, powder dust, etc.). In addition, do not put paper or cloth near or on the UV irradiation device, or it may
cause fire.or it may cause electrical shock.
• The UV lamp is made of glass and should not be dropped, hit against anything, given excessive force or scratched, or it
may cause damage to the UV lamp.
• Never look at the UV lamp being lit with your naked eyes, or it may cause pain in your eyes or visual impairment.Be sure
to wear safety glasses.
• Do not apply ultraviolet (UV) light directly to your skin, or it may cause irritation on your skin.
• The UV lamp may be damaged in rare cases. If it is damaged, contact a distributor in your district or our office to call for
service.
• Do not touch the lamp on or right after the lamp off with bare hands to avoid from burn injury.
• The UV lamp performance and service life are significantly affected by the UV irradiation and UV power supply units
used.Never use those UV devices other than those recommended by Mimaki.We would take no responsibility for any
troubles caused through the use of a UV devices not recommended by Mimaki.
• Touching hot parts such as the UV irradiation device with combustible materials may cause firing and/or smoking.
Leaving combustible materials under the UV irradiation device for a couple minutes may also cause firing and/or
smoking.
Notes on maintenance
• It is strongly recommended to use the machine in a room that is not dusty.
• Keep the front cover closed even when the machine is not printing. If not, dust can accumulate on the nozzles in the
heads.
• Dust in the heads can also cause drops of ink to fall suddenly down on the media during printing. In such a case, be
sure to clean up the heads. (P.4-19 “Cleaning the Head and the Area around It (every day)”)
• When cleaning the ink-station or the heads, make sure to wear the attached gloves.
• Perform wiping (removal of dust and paper powder) of the capping station and wiper frequently.
Periodic replacement parts
• Some parts of this machine must be replaced with a new one periodically by service personnel. Be sure to make a
contract with your distributor or dealer for After sale service to ensure a long life of your machine.
Disposition of this machine
• When discarding this machine, request the treatment of it for an industrial waste disposal contractor.
• Treat it properly in compliance with regulation in the local area.