MIMAKI JV400-130SUV, Operation Manual

Page: 42 / 194

2-12
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is "ON" ( P.3-14), the screen for entering media
remaining amount is displayed after detecting the media width.
1
Display the screen for entering media remaining
amount.
2
Press and key to enter the media remaining
amount.
3
Press the key.
Take-up device
With the switch of the take-up device, select the take-up direction of
the media or others.
Lever in top position (REVERSE) :
The take-up device winds the media with the printed side facing in.
Lever in middle position (OFF) :
The take-up device does not wind the media.
Lever in bottom position (FORWARD) :
The take-up device winds the media with the printed side facing out.
Setting the torque limiter
The take-up device is provided with a torque limiter.
The take-up torque can be adjusted with the torque limiter.
(The torque limiter is set at the maximum value when shipped from the factory.)
If the tension is too strong to use a thin sheet of media, lower the take-up torque with the torque limiter.
• Clockwise turn : Increases torque (a heavy and thicker media such as tarpaulin or the like)
• Counterclockwise turn : Decreases torque (For light media)
• When the torque limiter is adjusted too weak ;
The media can not be taken up firmly.
• When the torque limiter is adjusted too strong ;
The slack may occur depending on the media and cause influence on the image quality.
I n p u t o f Me d i a L e n g t h
= x x x . x m
I n p u t o f Me d i a L e n g t h
= 5 0 . 0m
50% of the maximum torque 100% of the maximum torque
Scale of the torque
Adjustment nut