MIMAKI JV400-130SUV, Operation Manual

Page: 24 / 194

1-12
Inserting ink cartridges
Insert an ink cartridges.
1
Slowly shake the white ink cartridge more than twenty times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.
Then, shake it more than twenty times right and left so that ink flows inside the cartridge.
2
Insert the ink cartridge.
• Insert the ink cartridge lengthwise with the surface having
IC chips pointing to the left side.
• For the setting orders of the ink cartridges, refer to P.6-4.
Changing an ink cartridge
Perform as follows when [INK END] or [INK NEAR END] is displayed on the display.
 When [INK END] is displayed
(1) Pull out an ink cartridge to be replaced.
(2) Insert a new ink cartridge, paying attention to the direction of IC chip.
 When [INK NEAR END] is displayed
There is a little of ink left. It is recommended to replace the ink cartridge soon since ink may become empty in
printing while printing is continuously enabled.
When you press the
key in LOCAL, you can check the cartridge to be replaced in the local guidance.
( P.3-41)
• If you shake it too strong, the pack inside may be damaged and it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt
the cartridge until it becomes vertical.
• When you changed the ink pack, be sure to change the IC chip, too.
A part
(the place to stick a needle) B part
(the slot on the bottom)
Cover with paper towel firmly
and shake ink slowly
Repeat this
A part