Microtronics myDatalogNANOamr, User Manual

Page: 46 / 125

9.1.1.2 Status LED
The status LED is used both to display the error/status codes and to indicate the current operating
state. If the ALOHA transmission mode was activated or the power supply was provided (PowerOn),
the status LED shows the current operating state for ten minutes. During these ten minutes, the
error/status codes are transmitted every three seconds.
Flashing
code
Description Solution/cause
0x Transport lock (GPRS OFF, measurement
OFF) If the ALOHA transmission mode is
initiated by the solenoid switch, the
myDatalogNANOamr switches back into
"RUN" mode (GPRS ON, measurement
ON).
1x Last connection OK ---
2x Last transmission faulty Try again later
4x Standby (GPRS ON, measurement OFF) see "transport lock"
6x Offline (GPRS OFF, measurement ON) see "transport lock"
7x Network block/no matching provider
l
Improve position of the antenna
l
Check whether the device is located
in the coverage area of a service
provider that is supported by the
integrated SIM chip
(www.microtronics.at/footprint)
8x No GSM network
l
Try again later
l
Improve position of the antenna
10x No GPRS connection Improve position of the antenna
11x No myDataweb server accessible
l
Check whether port 51241 is enabled
on the myDataweb server
l
Try again later
12x Faulty SIM chip Contact support
Error/status codes
Status LED Description
Flickering Establishing connection
Lights up
GPRS connection established or solenoid switchactuated
Off Normal measuring operation according to configuration until the next transmission
Operating states
46 Rev. 01