MI 3102(H) BT
Eurotest
XE
Instrument operation
21
Instrument is overheated. The measurement is prohibited until the
temperature decreases under the allowed limit.
Result(s) can be stored.
High electrical noise was detected during measurement. Results may be
impaired.
L and N are changed.
Warning!
High voltage is applied to the test terminals.
Warning!
Dangerous voltage on the PE terminal! Stop the activity
immediately and eliminate the fault / connection problem before proceeding
with any activity!
Test leads resistance in Continuity measurement is not compensated.
Test leads resistance in Continuity measurement is compensated.
High resistance to earth of test probes. Results may be impaired.
Too small current for declared accuracy. Results may be impaired. Check in
Current Clamp Settings if sensitivity of current clamp can be increased.
Measured signal is out of range (clipped). Results are impaired.
Single fault condition in IT system. (MI 3102 BT only)
Fuse F1 is broken.
4.1.4 Results
Measurement result is inside pre-set limits (PASS).
Measurement result is out of pre-set limits (FAIL).
Measurement is aborted. Consider displayed warnings and messages.
4.1.5 Sound warnings
Continuous sound
Warning!
Dangerous voltage on the PE terminal is detected
.
