10 GbE Gateway
(sRB-20210G Module) User Manual
Version 2.0
159
Mellanox Technologies
tx-reset
Description:
Resets the tx counters of the specific log.
Syntax:
tx-reset [counter]
Example:
sRB-20210G-61f0(statistic)# log show
counter tx total pack tx total byte rx total pack rx total byte
|-------|--------------|--------------|--------------|-----------
---
1 0 0 28 2744
2 0 0 12 2349
3 0 0 0 0
4 0 0 0 0
14.6
Configuration (Config) Commands
Configuration commands apply to features that affect the system as a whole, rather than just
one protocol or interface.
Config
mode is entered through
Privileged
mode using the
config
command.
In
Config
mode, you can access the following modes:
Cluster
,
Interface
,
Route
,
Service
,
SNMP
, and
TFM
, as described in Sections
14.6.1 –
The following are the available commands in the
Config
mode:
sRB-20210G-61f0(config)# ?
<command> ? Displays the command's usage string.
? Displays the list of available commands.
cluster Changes to Cluster configuration mode.
diagnostics Changes to Diagnostics configuration mode.
end Ends the CLI.
exit Exits to previous menu.
factory-default Sets the 10GbE Gateway back to factory default,
and reboots the system.
interface Changes to Interface configuration mode.
ntp Changes to NTP configuration mode
policy Changes to Policy mode.
port Changes to Port configuration mode.
remote Changes to Remote configuration mode
route Changes to Route configuration mode.
security Changes to Security configuration mode.
snmp Changes to SNMP configuration mode.
system-name set Sets the system name of this computer.
system-name show Shows the system name of this computer.
tfm Changes to TFM configuration mode.
The following details the commands and sub-menus available under the
Config
menu:
