10 GbE Gateway
(sRB-20210G Module) User Manual
Version 2.0
139
Mellanox Technologies
Chapter 14.
Command Line Interface (CLI)
Management
This chapter provides reference for the Command Line Interface (CLI), which can be used
instead of the GUI for configuration and management of the gateway.
14.1
Starting a CLI Management Session
To start a CLI management session via serial connection to the switch:
Step 1
Connect the PC to the switch via its serial port, using the cable supplied by Mellanox.
Step 2
Start a HyperTerminal client (or compatible) on the computer.
Step 3
Configure the terminal emulation parameters
Step 4
Type the appropriate user name (admin or guest) and password at the logon prompt. Note
that the password is represented by stars ********.
guest
a. Enter the guest mode. The default password for the guest user is
voltaire.
b. Enter the Privileged mode as follows:
Type
enable
and enter the
admin
password (the default password for the admin
user is
123456
.)
OR
admin
Enter directly the privileged mode.
The default password for the admin user is
123456
.
Step 5
Issue the appropriate CLI commands to complete the required actions.
NOTE:
When the 10 GbE CLI syntax included parameters in brackets [ ], you must include at least
one of the parameters in the command.
14.2
Mellanox CLI Model
The Mellanox sRB-20210G CLI model consists of a hierarchical structure of the menus and
sub-menus, as shown in the diagram below. For further detail, refer to the sRB-20210G CLI
Reference, in
