10 GbE Gateway
(sRB-20210G Module) User Manual
Version 2.0
143
Mellanox Technologies
Table
14-4. CLI Main Modes
CLI mode
Prompt
Access
Method
Exit Method
exec
sRB-20210G-[BoxID]>
Log in
Use the
end
command to exit
the CLI.
privileged
sRB-20210G-[BoxID]#
From the
Exec mode,
use the
command.
To exit back to user Exec
mode, use the
disable
or
exit
command.
To enter global configuration
mode, use the
config
command.
Use the
end
command to exit
the CLI.
config
sRB-20210G-[BoxID](
config)#
From the
Privileged
mode, use
the
command.
To exit back to Privileged
mode, use the command.
To enter the interface
Configuration mode (interface
sub-menu), use the command.
Use the
end
command to exit
the CLI.
NOTE:
Debug mode is for Mellanox internal use only.
14.4
Exec Mode Commands
The commands available to the user at any given time depend on the current mode. Entering a
question mark (?) at the system prompt allows the user to obtain a list of commands available
for each command mode.
When the user starts a session on the sRB-20210G, the initial mode is User mode, often called
Exec or Admin mode. Only a limited subset of the commands is available in Exec (Admin)
mode.
When a CLI session is started, the user enters the Exec mode that allows view-only access of
Switch configuration parameters.
In order to have access to all commands, the user must enter Privileged Mode. Normally, the
user must enter a password to enter Privileged Mode. From the Privileged Mode, the user can
enter any Exec command since they are also listed in that mode or enter the Configuration
Mode. From this menu, the user can also go back to Exec Mode.
The following are the commands available in the Exec Mode.
NOTE:
The > prompt indicates that you are in Exec Mode.
