Marport Scala2, User Manual

Page: 45 / 177

Scala2 | Version 5 | System Configuration
3. Choose the type of connection between serial port, UDP or TCP socket.
4. Enter the output parameters.
• Serial port: select the name of the port and baud rate of the device.
• UDP: enter the port number from which data are broadcast. Then, click the
Interface menu
to select the IP address of the connected device (refer to your network preferences).
Note: The logical network interface (such as en0, en1) associated with the IP
addresses differs from one computer to another. If doing the same installation on
another computer, do not enter the same interface on purpose.
• TCP: enter the port number from which data are sent.
5. Under the Data to Emit tab, select which data you want to output:
• Select Emit Sensor Data to output data that is received on Scala2 from Marport sensors, with
or without filters.
• Select Emit trawl positioning sentence if you need to send positioning data to another
system (such as a cartography software) and choose the sentence corresponding to this
system.
• In ScalaReplay2, select Re-emit NMEA sentences to send NMEA data (for example
positioning data) to another software interfacing with Scala2 (such as a cartography
software) in order to replay data that was recorded.
Note: Scala2 can output NMEA data for trawl door positioning with the following
sentences:
• $PSIMS (Olex)
• $PTSAL (MaxSea version 12 and SeaPix)
• $PMPT (TimeZero)
| 44