Marport Scala2, User Manual, Page: 43 / 177

Scala2 | Version 5 | System Configuration
Receiving Warp Lengths from Scantrol
You can output warp length data from Scantrol iSYM Trawl Control application to Scala2 software.
About this task
Note: In this procedure, data are transmitted via a UDP port but a connection via a serial
port can be possible.
Procedure
1. Scantrol and Marport computers must be connected together via an Ethernet wired network.
Both computers must be on the same sub-network to communicate with each other:
192.168.0.XX.
For example, the network IP address can be set at
192.168.0.10 on Scantrol computer and at
192.168.0.12 on Marport computer. The subnet mask address is 255.255.255.0 for both.
2. Go to iSYM's Configure Communication Ports menu, then in 13: NMEA UDP 1 enter a port
number, such as
9000
, and set SEND to
1
.
Note: The port number must be different from the one on which Scala2 sends data (if
applicable).
3. In Scala2, open the control panels then click NMEA Inputs > Add input .
4. Set a UDP connection and enter the corresponding port.
| 42