6 - Adjustments
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 349 of 356 (
D99875607-91
)
If you reached a
minimum
for the
Tipper Motor Angle
setting and the device is still overflashing,
decrease
the
Tipper Motor Time
setting by steps of 1ms until the tipper covers properly.
6.8.6
Calibrate Foil Cool Time
During the tipping cycle, the hot tipper fuser presses the foil against the card, holds for a certain amount
of time, then stops heating and cools down before it pulls the foil off the card. If the foil is not being
allowed to cool long enough, the device may malfunction. If the foil is being left to cool for too long the
device may be slow or may malfunction. A typical Foil Cool Time is 40ms. There are no specific
calibration steps for adjusting the tipper cooling time.