5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 224 of 356 (
D99875607-91
)
5.21.5
Pack
To pack the embosser and tools in the replacement packaging for return to MagTek, reverse the
unpacking steps from the beginning of this section:
1)
Use the pliers and the 1/8” hex wrench to fasten the indenter (if any) to the embosser using the three
nuts and bolts you set aside earlier.
Figure 5-91 - Nuts and Bolts Holding Replacement Indenter to Replacement Embosser
8)
Use the 7/16” combo wrench (and the 5/32” hex wrench if necessary) to bolt the embosser to the
bottom of the box.
Figure 5-92 - Replacement Embosser Attached to Shipping Box Bottom
2)
Turn the embosser upside down and place it on top of the box, making sure to insert the four tabs on
the box into the four slots in the bottom of the box.