4 - Preventive Maintenance Procedure (EC3000)
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 68 of 356 (
D99875607-91
)
4.10
Clean Inside the Device
Do not use alcohol wipes, liquids, or chemicals on the touchscreen.
Clean the device in phases to avoid blowing dirt, dust, or debris into sensitive components:
1)
Remove all remaining consumables from the device (stock cards, image printer ribbon, indent
cartridge[s], tipper foil, etc.) and set them aside in a secure location or give them to the customer for
temporary storage or secure disposal.
2)
If there is a large, visible amount of dirt, dust, or debris in the device, wipe the worst of it out with a
clean, dry cloth.
3)
Wipe remaining dirt, dust, and debris off the base plate and main components with alcohol wipes.
4)
Use compressed air to blow out any remaining dirt, dust, or debris from between components and re-
wipe as necessary.
5)
Use compressed air to clean each of the sensors (see section
2.9.2 How to Use the Sensor Utility
for an inventory of all sensors in the device).
6)
Use compressed air to clean out the electronics in the bottom between the side access doors, with
special attention paid to the power supply in the rear left corner.
4.11
Service the Image Printer Module
Follow these steps to service the image printer:
1)
Make sure the interior of the ExpressCard is clean (see section
).
Performing image printer maintenance with dirt or debris inside the cover may damage the printer.
2)
Open the image printer and clean its interior if necessary. Dust and other particles are attracted to the
image printer ribbon or card stock by static produced during image printing, and can contaminate
image-printed cards, causing spots or speckles.
3)
Clean the image printer dust filter per
D998200281 ExpressCard 3000 Installation and Operation
Manual
.
4)
Check handoff from image printer to XY transport. Adjust if needed (see section
Calibrate Printer to XY Transport Handoff
