5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 92 of 356 (
D99875607-91
)
5.4.2
Remove
Follow these steps to remove the right side cover:
1)
Prepare the device for replacing parts by following the steps in section
Device for Removing / Re-installing Modules
. At the end, the device should be powered down with
all external cables safely disconnected and the hopper shuttle parked near the front of the device.
2)
Remove the top access door by following the steps in section
5.5 How to Remove / Re-install the
, including safely powering down and disconnecting external cables.
3)
Remove the magnetic stripe reader (MSR) from the case by following the steps in section
to Remove / Re-install the Magnetic Stripe Reader (MSR) Module
4)
Remove all the card stock hoppers from the device and set them aside. Remember to move the
hopper shuttle out of the way as you remove them (see section
2.8 How to Safely Move Transports
5)
Remove the whole cover by following the steps in section
5.3 How to Remove / Re-install the
6)
Remove the touchscreen by following the steps in section
5.36 How to Remove / Re-install the
7)
Lay the cover on a flat surface and remove the three screws that attach the right side cover to the
whole cover.
Figure 5-23 - Right Side Cover Screws
8)
Remove the right side cover.